Chapter Contents

Previous

Next

Using the PRTFILE Command

The PRTFILE command enables you to change the control information for a file that you are routing to a printer. For example, if you want to send a file to a printer queue other than the default, submit the following FILENAME statement:

filename woutput printer queue=myqueue;

Then you can issue the following series of commands from the command line of a window to send the contents of the window to the MYQUEUE printer queue:

prtfile woutput
print
free

After you issue the PRTFILE command, a note in the SAS log indicates that the output was sent to a file named SAS nnnn.DAT. This is a temporary file that is deleted when you issue the PRINT command.

As another example, the following FILENAME statement associates the fileref MYFILE with the external file [MYDIR]SPECIAL.SAS and specifies that the carriage-control format is FORTRAN:

filename myfile '[mydir]special.sas' cc=fortran;

Then the following series of commands from the command line of a window sends the contents of the window to the external file SPECIAL.SAS:

prtfile woutput
print myfile
free

Note:    Do not use the PRTFILE command with the FSFORM command. For information about the FSFORM command, see Host-Specific Frames of the FORM Window.  

Chapter Contents

Previous

Next

Top of Page

Copyright © 1999 by SAS Institute Inc., Cary, NC, USA. All rights reserved.