Chapter Contents

Previous

Next

RESET Statement

RESET options ;

The RESET statement is used to change options after the LP procedure has started execution.

All of the options that can be set in the PROC LP statement can also be reset with the RESET statement, except for the DATA=, the PRIMALIN=, and the ACTIVEIN= options. In addition to the options available with the PROC LP statement, the following two options can be used.

LOWER(colnames)=n;

during phase 3, this sets the lower bound on all of the structural variables listed in the colnames list to an integer value n. This may contaminate the branch and bound tree. All nodes that descend from the current problem have lower bounds that may be different from those input in the problem data set.

UPPER(colnames)=n;

during phase 3, this sets the upper bound on all of the structural variables listed in the colnames list to an integer value n. This may contaminate the branch and bound tree. All nodes that descend from the current problem have upper bounds that may be different from those input in the problem data set.

Chapter Contents

Previous

Next

Top

Copyright © 1999 by SAS Institute Inc., Cary, NC, USA. All rights reserved.