Chapter Contents

Previous

Next

S370FPIBw.d

Category:	Numeric
Alignment:	left

Syntax Description

w

specifies the width of the output field.

Default:	4
Range:	1-8

d

optionally specifies to multiply the number by 10^d.

Details

Positive integer binary values are the same as integer binary values, except that all values are treated as positive. S370FPIBw.d writes integer binary values with consistent results if the values are created in the same type of operating environment that you use to run SAS.

Use S370FPIBw.d to write positive integer binary data in IBM mainframe format from data that are created in other operating environments.

Note:    Different operating environments store integer binary values in different ways. This concept is called byte ordering. For a detailed discussion about byte ordering, see Byte Ordering on Big Endian and Little Endian Platforms.  

Comparisons

• If you use SAS on an IBM mainframe, S370FPIBw.d and PIBw.d are identical.

• The S370FPIBw.d format is the same as the S370FIBw.d format except that the S370FPIBw.d format treats all values as positive values.

• S370FPIBw.d, S370FIBUw.d, and S370FIBw.d are used to write big endian integers in any operating environment.

  To view a table that shows the type of format to use with big endian and little endian integers, see SAS Formats and Byte Ordering.

  To view a table that compares integer binary notation in several programming languages, see Integer Binary Notation and Programming Languages.

Examples

y=put(x,s370fpib1.);
put y $hex2.;

Values	Results*
	----+----1
	0C
*The result is a hexadecimal representation of a one-byte binary number written in positive integer binary format, which occupies one column of the output field.

See Also

Formats: S370FIBw.d, S370FIBUw.d

Chapter Contents

Previous

Next

Top of Page

Copyright © 1999 by SAS Institute Inc., Cary, NC, USA. All rights reserved.