Chapter Contents

Previous

Next

RMFDURw.

Category:

Date and time

Syntax Description

w

specifies the width of the input field.

Requirement:

w must be 4 because packed decimal duration values in RMF records contain four bytes of information.

Details

The RMFDURw. informat reads the duration of RMF measurement intervals of RMF records that are produced as packed decimal data by IBM mainframe systems and converts them to SAS time values.

The general form of the duration interval data in an RMF record in hexadecimal notation is mmsstttF, where

mm

is the one-byte representation of two digits that correspond to minutes.

ss

is the one-byte representation of two digits that correspond to seconds.

ttt

is the one-and-a-half-bytes representation of three digits that correspond to thousandths of a second.

F

is a half byte that contains all binary 1s, which assigns the value as positive.

Comparisons

• Both the RMFDURw. informat and the RMFSTAMPw. informat read packed decimal information from RMF records that are produced by IBM mainframe systems.

• The RMFDURw. informat reads duration data and results in a time value.

• The RMFSTAMPw. informat reads time-of-day data and results in a datetime value.

Examples

input dura rmfdur4.;

Data Lines *		Results
----+----1----+
3552226F		2152.266
*The data line is a hexadecimal representation of a binary duration value that is stored in packed decimal form as it would appear in an RMF record. Each byte occupies one column of the input field. The result is a SAS time value corresponding to 00:35:52.226.

See Also

Informats: RMFSTAMPw. SMFSTAMPw.

Chapter Contents

Previous

Next

Top of Page

Copyright © 1999 by SAS Institute Inc., Cary, NC, USA. All rights reserved.