Chapter Contents

Previous

Next

DRAW Function

Updates:

XLAST, YLAST

Associated Variables

COLOR='color'

specifies the color of the line that is being drawn. Color can be any SAS/GRAPH color name.

GROUP=group-value
MIDPOINT=midpoint-value
SUBGROUP=subgroup-value

specify coordinates for HBAR and VBAR charts from the GCHART procedure. Use these variables only with the data coordinate systems 1, 2, 7, and 8.

HSYS='coordinate-system'

specifies the coordinate system for the SIZE variable. See HSYS Variable for an explanation of coordinate-system.

LINE=1...46

specifies the line type of the line that is being drawn. See Specifying Line Types for an illustration of the line types.

SIZE=line-thickness

specifies the thickness of the line that is being drawn. The units depend on the value of the HSYS variable. For example, if HSYS='3', the SIZE variable is in units of percent of the graphics output area. If HSYS='4', the SIZE variable is in units of cells of the graphics output area.

As the thickness of the line increases, it may be impossible to center around a given coordinate. For example, if you specify a thickness of value 2 and HSYS='4', the first line is drawn at the (X, Y) coordinates. The second is drawn slightly above the first. The exact amount varies by device, but it is always one pixel in width. A thickness of value 3 produces one line above, one line at, and one line below the (X, Y) coordinate position. See Sample Line Thicknesses Used with the SIZE Variable for examples of line thicknesses.

Sample Line Thicknesses Used with the SIZE Variable

WHEN='B' | 'A'

specifies when to draw the line in relation to other procedure output. See WHEN Variable.

X=horizontal-coordinate
Y=vertical-coordinate
Z=depth-coordinate (PROC G3D only)
XC='character-type-horizontal-coordinate'
YC='character-type-vertical-coordinate'

specify the endpoint of a line drawn from (XLAST, YLAST) to (X,Y).

XSYS='coordinate-system'

specifies the coordinate system for the X or XC variable. The XC variable can be used only with XSYS='2'. See XSYS Variable for an explanation of coordinate-system.

YSYS='coordinate-system'

specifies the coordinate system for the Y or YC variable. The YC variable can be used only with YSYS='2'. See YSYS Variable for an explanation of coordinate-system.

ZSYS='coordinate-system'

specifies the coordinate system for the Z variable (PROC G3D only). See ZSYS Variable for an explanation of coordinate-system.

Chapter Contents

Previous

Next

Top of Page

Copyright © 1999 by SAS Institute Inc., Cary, NC, USA. All rights reserved.